MSI K9A2 PLATINUM PROMISE RAID DRIVER

April 11, 2019 posted by

You would have to remove one IDE optical device though I think you can run Linux on your raid Just to make sure: When going into bios i see where in the sata menu you can choose enable or disable sata, and under that you can choose ide raid or ahci I’ll try the MSI forums and see what I can come up with. Are you able to update your kernel? Find More Posts by viron.

Uploader: Kigagrel
Date Added: 28 October 2004
File Size: 41.96 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 40220
Price: Free* [*Free Regsitration Required]

Please visit this page to clear all LQ-related cookies. But there shouldn’t be any need for that, as you should be able to delete and rebuild arrays as much as you like to I have connected both drives to the platonum controller and put the sb to IDE Phenom Quad-core 2.

Suspicious Activity Detected

If so, can I set this up using the Promise controller? By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features.

Tried same thing on the promise T3 controller as well. I started by getting the driver compiled on a supported kernel 2. Just replace the failed drive and of you go again. The store will probably replace it without asking questions.

Last Drivers  RAPOO 8200P DRIVER

Just got a delayed write failure on one of the 2 gb and then blue screened. I’ve been following this thread for some time and have tried every possible solution to get these two ports on my mobo to work but no matter what I can’t get the driver to compile. You C drive should show a total size of both the sizes you installed.

Are you saying that Raid option cannot be relied on on this board whatsoever?

I have a similar setup: The colors of the slots represent the channels, one color for channel A and the other for channel B. You will get a better performance and you do have your data secured: It getting to be so frustrating Using the live cd I downloaded the kernel source and build-essential packages plaatinum ncurses for menuconfig. During the install, after the network is pgomise, I go to another VT and copy my driver over to the modules dir where the install uses to detect the Raie controller.

Once this is done, I’m able to insmod it just fine. My motherboard came with version 1. I’m running fedora 9 64bit. I’m not sure what difference that makes. Hi guys, I’m having a few problems setting up the tx card.

Last Drivers  HICAP100-S2 DRIVERS

Originally Posted by viron.

And when I go to the see the Array status it shows the Seagate drive on ID channel 1, but for the 2nd drive it shows questions marks all the way through the item line. Before I start on what I found about your problem, I’d like to make 2 suggestions about what to post: I don’t think so. I’m not exactly sure what you meant by “create a container for it” unless you assumed I had multiple devices plugged into the controller.

What distro are you using, which kernel?

Drivers for Promise PDC RAID Controller on MSI K9A2 Platinum Motherboard – Page 2

Click Here to receive this Complete Guide absolutely free. The time now is The latter setting will not effect the Promise T3, but it will cause the system to hang upon OS loading when the proper driver isn’t used Page 3 of 3. I was under the impression we were both using the same motherboard.